LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 600 (Power Steering System) >> Steering Gear And Linkage Disassembly >> Locknut (adjusting cover), Adjusting Cover Disassembly Note

Locknut (adjusting cover), Adjusting Cover Disassembly Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the locknut (adjusting cover) from the gear housing using the SST. 
    CAUTION:
    • If a tool is installed to the SST (49 E032 308), install the tool so that it is perpendicular to the SST as shown in the figure. If the tool is not installed as instructed, the SST can separate from the locknut easily which could cause damage to the locknut while doing the work.
  2. Remove the adjusting cover from the gear housing
    Fig 1: Using SSTs For Removing Locknut (Adjusting Cover) From Gear Housing
    G06200237Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals