LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 600 (Power Steering System) >> Steering Gear And Linkage Assembly >> Seal Ring Assembly Note

Seal Ring Assembly Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply ATF to the surface of the SST  (49 E032 305).
  2. Press the seal ring from the tapered side of the SST  , and slide it to the end of the SST  while pressing the seal ring uniformly.
    Fig 1: Pressing Seal Ring From Tapered Side Of SST
    G06200269Courtesy of MAZDA MOTORS CORP.
  3. Align the end of the SST  (seal ring assembly side) with the sleeve groove.
  4. Slide and assemble the seal ring to the sleeve groove
  5. Repeating Steps  1 to  4, assemble the 4 seal rings.
    Fig 2: Sliding Seal Ring To Sleeve Groove
    G06200270Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals