Clip Installation Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Install a new joint shaft clip to the clip groove at the end of the joint shaft with the clip opening facing upward and the clip width within the specification.
After installation, measure the outer diameter.
- If it exceeds the specification, repeat installation using a new clip.
  Standard
  
  L5: 31.2 mm {1.23 in} or less
  
  MZI-3.7: 34.0 mm {1.34 in} or less
  
  Fig 1: Identifying Joint Shaft Clip And Clip Opening
  Courtesy of MAZDA MOTORS CORP.