LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 598 (Drive Shaft) >> Drive Shaft Removal/Installation >> Drive Shaft Installation Note >> Right side

Right side

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new clip onto the joint shaft. See JOINT SHAFT REMOVAL/INSTALLATION .
  2. Apply grease (L2Y1 33247) to the wheel bearing inner race and drive shaft contact surface (Area A, in figure)
  3. Insert the drive shaft to the wheel hub.
  4. Insert the drive shaft to the joint shaft.
  5. After installation, pull the transaxle side outer ring forward to confirm that the drive shaft is securely held by the clip
    Fig 1: Identifying Wheel Bearing Inner Race And Drive Shaft Contact Surface (Area A)
    G06205470Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals