Clip installation Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Install a new drive shaft clip to the clip groove at the end of the drive shaft with the clip opening facing upward and the clip width within the specification.
Standard

L5: 31.2 mm {1.23 in} or less

MZI-3.7: 34.0 mm {1.34 in} or less
After installation, measure the outer diameter.
- If it exceeds the specification, repeat installation using a new clip.
  
  Fig 1: Identifying Drive Shaft Clip And Clip Opening
  Courtesy of MAZDA MOTORS CORP.