Tripod Joint, Snap Ring Assembly Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

While aligning the marks on the shaft and the tripod joint, insert the tripod joint using a bar and a hammer.
CAUTION:
- Do not tap the roller with a hammer.
Insert a new snap ring using snap ring pliers.
CAUTION:
- Be sure the snap ring engages correctly in the groove of the shaft.
  
  Fig 1: Inserting Tripod Joint Using Bar And Hammer
  Courtesy of MAZDA MOTORS CORP.