Boot band (Large diameter side)

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Adjust clearance C by turning the adjusting bolt of the SST .
Clearance C

3.2 mm {0.13 in}

Fig 1: Adjusting Clearance C By Turning Adjusting Bolt Of SST
Courtesy of MAZDA MOTORS CORP.
Crimp the wheel side small boot band using the SST . Verify that clearance D is within the specification.
- If clearance B is more than the specification, reduce clearance C of the SST and crimp the boot again.
- If clearance B is less than the specification, replace the boot band, increase clearance C of the SST , and crimp the new boot.
  Clearance D
  
  2.4-2.8 mm {0.10-0.11 in}
  
  Fig 2: Crimping Wheel Side Small Boot Band Using SST
  Courtesy of MAZDA MOTORS CORP.
Verify that the boot band does not protrude from the boot band installation area.
- If it does, replace the boot band and repeat Steps 2 and 3.