Boot Assembly Note
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- The boot shapes on the wheel side and the differential side are different. Do not install the wrong boot by mistake.
- Fill the inside of the new dust boot (wheel side) with grease.CAUTION:
- Do not touch the grease with your hand. Apply it from the tube to prevent foreign matter from entering the boot.
Grease amount
L5 (AT): 100-120 g {3.53-4.23 oz.}
MZI-3.7: 110-130 g {3.89-4.58 oz.}
- Install the boot with the drive shaft spline still wrapped with vinyl tape.
- Remove the vinyl tape.