LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 598 (Drive Shaft) >> Drive Shaft (Double Offset Joint) Disassembly/Assembly >> Cage, Inner Ring, Balls, Snap Ring Assembly Note

Cage, Inner Ring, Balls, Snap Ring Assembly Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the marks and install the balls and cage to the inner ring in the direction shown in the figure.
    CAUTION:
    • Install the cage so that the major diameter is at the same side as the snap ring groove. If incorrectly installed, the drive shaft may become disengaged.
  2. Align the marks and install the inner ring to the shaft.
  3. Install a new snap ring.
scientia non olet · About LEMON Manuals