LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 598 (Drive Shaft) >> Drive Shaft (Double Offset Joint) Disassembly/Assembly >> Boot Assembly Note

Boot Assembly Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • The wheel-side and transaxle-side boots are different.
  1. Fill the boot (wheel side) with the specified grease.
    CAUTION:
    • Do not touch grease with your hand. Apply it from the tube to prevent foreign matter from entering the boot.

    Grease amount 

    100-120 g {3.53-4.23 oz.} 

  2. Install the boot with the splines of the shaft still wrapped in tape from disassembly.
  3. Remove the tape.
scientia non olet · About LEMON Manuals