LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 597 (Exterior Trim) >> Rear Finisher Removal/Installation

Rear Finisher Removal/Installation

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the trunk lid trim See. TRUNK LID TRIM REMOVAL/INSTALLATION .
  3. Disconnect the request switch connector
  4. Remove the nut A and nut C.
  5. Pull the rear finisher outward, then disengage clip B.
  6. Remove the rear finisher.
  7. Install in the reverse order of removal.
    Fig 1: Identifying Trunk Lid Trim Nuts And Clips
    G06199435Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals