Warm Up Three Way Catalytic Converter (WU-TWC) (RH) Installation Note
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Be sure to follow the procedure below in installing the components. Otherwise improper fastening or seating may occur.
- Tighten nut of D with tightening torque
Tightening torque
34-46 N.m {3.5-4.6 kgf.m, 26-33 ft.lbf}
- Temporarily tighten bolt of E
- Temporarily tighten nut of F
- Temporarily tighten bolt of G
- Tighten nut of F with tightening torque
Tightening torque
34-46 N.m {3.5-4.6 kgf.m, 26-33 ft.lbf}
- Tighten bolt of G with tightening torque
Tightening torque
17-23 N.m {1.8-2.3 kgf.m, 13-16 ft.lbf}
- Tighten bolt of E with tightening torque
Tightening torque
17-23 N.m {1.8-2.3 kgf.m, 13-16 ft.lbf}