Exhaust Manifold (RH) Installation Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Tighten the exhaust manifold (RH) installation nuts in the order shown in the figure
Tightening torque

22-28 N.m {2.3-2.8 kgf.m, 17-20 ft.lbf}

Fig 1: Identifying Exhaust Manifold Nuts (RH) Tightening Sequence
Courtesy of MAZDA MOTORS CORP.