Basic Inspection [Aw6A-El]

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

STEP	INSPECTION		ACTION
1	Measure the battery voltage Is the battery voltage 10.0-14.0 V ?	Yes	Go to the next step.
1		No	Replace or recharge the battery. (See BATTERY RECHARGING [MZI-3.7] .)
2	Inspect the TCM related harnesses, connectors and fuses. Are they normal?	Yes	Go to the next step.
2		No	Repair or replace any malfunctioning parts according to the inspection result
3	Warm up the engine to normal operating temperature. Retrieve DTC using the M-MDS Is there any DTC present?	Yes	Record Freeze Frame Data and perform appropriate DTC troubleshooting procedures
3		No	Go to the next step.
4	Perform the road test. Is the ATX operating normally?	Yes	Go to the next step.
4	Perform the road test. Is the ATX operating normally?	No	Repair or replace any malfunctioning parts according to the inspection result.
5	Perform the time lag test Is the ATX operating normally?	Yes	Go to the next step.
5	Perform the time lag test Is the ATX operating normally?	No	Repair or replace any malfunctioning parts according to the inspection result
6	Perform the stall test Is the stall speed within the specified?	Yes	Go to the next step.
6		No	Repair or replace any malfunctioning parts according to the inspection result
7	Perform the line pressure test Is the line pressure within the specified?	Yes	Perform the symptom troubleshooting and follow the procedures.
7		No	Repair or replace any malfunctioning parts according to the inspection result
8	Inspect following part or signal related PIDs using the M-MDS. APP sensor TSS VSS TFT sensor TR switch M range switch Up switch Down switch Brake switch Engine speed Are they normal?	Yes	Perform the symptom troubleshooting and follow the procedures.
8		No	Repair or replace any malfunctioning parts according to the inspection result