TR switch Installation Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Verify that the manual shaft is aligned with N position

Fig 1: Identifying Manual Shaft N Position
Courtesy of MAZDA MOTORS CORP.
Adjust the TR switch between terminals B and C until the resistance becomes 713-788 ohms.

Fig 2: Identifying TR Switch Connector Terminals

Courtesy of MAZDA MOTORS CORP.

Tighten the TR switch installation bolts.
Tightening torque 8-11 N.m {82-112 kgf.cm, 71-97 in.lbf}