Operating inspection

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Do not apply battery position voltage to terminals for more than 3 s.

NOTE:

Because the operation sound of the solenoid valve is small, perform inspection in a quiet place.

Disconnect the coupler component connector.
1. Disconnect the negative battery cable.
2. Remove the battery and battery tray.
3. Disconnect the coupler component connector.
  
  Fig 1: Locating Coupler Component
  Courtesy of MAZDA MOTORS CORP.
Apply battery positive voltage to the coupler component terminals A, B and battery negative voltage to GND, and verify that operating sound is heard from solenoid valve.
- If the operation sound is not heard, inspect the coupler component for continuity. If coupler component has no malfunction, perform the "Off-vehicle inspection". (See OFF-VEHICLE INSPECTION .)
  
  Fig 2: Identifying Coupler Component Connector
  Courtesy of MAZDA MOTORS CORP.