LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 592 (Automatic Transaxle [Service, Removal & Installation FS5A-El)) >> Solenoid Valve Inspection [FS5A-El] >> Secondary Control Valve Body >> On-vehicle inspection

On-vehicle inspection

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the coupler component connector.
    1. Disconnect the negative battery cable.
    2. Remove the battery and battery tray.
    3. Disconnect the coupler component connector.
      Fig 1: Locating Coupler Component
      G06205894Courtesy of MAZDA MOTORS CORP.
  2. Measure the resistance between the coupler component terminals A and B.
    • If there is any malfunction, inspect the coupler component for continuity. If coupler component has no malfunction, perform the "Off-vehicle inspection". (See OFF-VEHICLE INSPECTION .)
      SOLENOID VALVE SPECIFICATION

      Solenoid valve Terminal Resistance (ohm)
      Pressure control solenoid B A<=>GND 1.0-4.2
      Shift solenoid F B<=>GND 8.4-21.8
      Fig 2: Identifying Coupler Component Connector Terminal
      G06205895Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals