Off-Vehicle inspection

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Measure the resistance between the coupler component terminals.
- If there is any malfunction, replace the solenoid valve. (See SOLENOID VALVE REMOVAL/INSTALLATION [FS5A-EL] .)
  Pressure control solenoid A specification 2.4-7.3 ohms
  
  Fig 1: Identifying Pressure Control Solenoid A Connector
  Courtesy of MAZDA MOTORS CORP.
  
  Shift solenoid A, B, C specification 1.0-4.2 ohms
  
  Fig 2: Identifying Shift Solenoid A, B, C Connector
  Courtesy of MAZDA MOTORS CORP.
  
  Shift solenoid D, E specification 10.9-26.2 ohms
  
  Fig 3: Identifying Shift Solenoid D, E Connector
  Courtesy of MAZDA MOTORS CORP.