LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 592 (Automatic Transaxle [Service, Removal & Installation FS5A-El)) >> Mechanical System Test [FS5A-El] >> Mechanical System Test Preparation

Mechanical System Test Preparation

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Engage the parking brake and use wheel chocks at the front and rear of the wheels.
  2. Inspect the engine coolant. (See ENGINE COOLANT LEVEL INSPECTION [L5] .)
  3. Inspect the engine oil. (See ENGINE OIL LEVEL INSPECTION [L5] .)
  4. Inspect the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION [FS5A-EL] .)
  5. Inspect the idle speed. (See ENGINE TUNE-UP [L5] .)
  6. Inspect the ignition timing. (See ENGINE TUNE-UP [L5] .)
  7. Verify that no DTCs recorded. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FS5A-EL] .)