LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 592 (Automatic Transaxle [Service, Removal & Installation FS5A-El)) >> Drive Plate Removal/Installation [FS5A-El] >> Drive Plate Installation Bolts Removal Note

Drive Plate Installation Bolts Removal Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the SST against the drive plate.
  2. Loosen the drive plate installation bolts in two or three steps in the order as shown in the figure, then remove the bolts and the drive plate.
    Fig 1: Identifying Drive Plate Installation Bolt Removal Sequence
    G06205925Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals