On-Board Diagnostic System Simulation Inspection [Aw6A-El]
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the M-MDS to the DLC-2.
- After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- When using the IDS (laptop PC)
- Select "DataLogger".
- Select "Modules".
- Select "TCM".
- When using the PDS (Pocket PC)
- Select "Module Tests".
- Select "TCM".
- Select "DataLogger".
- When using the IDS (laptop PC)
- Select the active command modes from the PID table.
- Perform the active command modes, inspect the operations for each parts.
- If the operation of output parts cannot be verified after the active command mode inspection is performed, this could indicate the possibility of an open or short circuit, sticking, or operation malfunction in the output parts.SIMULATION ITEM TABLE
Item Related to Unit/Condition Test condition LPS Pressure control solenoid A Ignition ON or idling (P or N position) SSA Shift solenoid A On/Off Ignition ON or idling (P or N position) SSB Shift solenoid B On/Off Ignition ON or idling (P or N position) SSC Shift solenoid C A Ignition ON or idling (P or N position) SSD Shift solenoid D A Ignition ON or idling (P or N position) SSE Shift solenoid E A Ignition ON or idling (P or N position) SSF Shift solenoid F A Ignition ON or idling (P or N position) TCCC TCC control solenoid A Ignition ON or idling (P or N position)
- If the operation of output parts cannot be verified after the active command mode inspection is performed, this could indicate the possibility of an open or short circuit, sticking, or operation malfunction in the output parts.