DTC P2762:00 [Aw6A-El]: Notes

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DETECTION CONDITION AND POSSIBLE CAUSE

DTC P2762:00	TCC control solenoid range/performance (stuck)
DETECTION CONDITION	Feedback current corresponding to solenoid current command value is irregular when engine is running. Diagnostic support note: The MIL illuminates if the TCM detects the above malfunction condition during the first drive cycle. The AT warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle. PENDING CODE is not available. FREEZE FRAME DATA is available. The DTC is stored in the TCM memory.
POSSIBLE CAUSE	Deteriorated ATF ATF level low Line pressure malfunction Oil pump malfunction Control valve stuck TCC control solenoid stuck TCM malfunction

DTC P2762:00

TCC control solenoid range/performance (stuck)

DETECTION CONDITION

Feedback current corresponding to solenoid current command value is irregular when engine is running.

Diagnostic support note:

The MIL illuminates if the TCM detects the above malfunction condition during the first drive cycle.
The AT warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
PENDING CODE is not available.
FREEZE FRAME DATA is available.
The DTC is stored in the TCM memory.

POSSIBLE CAUSE

Deteriorated ATF
ATF level low
Line pressure malfunction
- Oil pump malfunction
- Control valve stuck
TCC control solenoid stuck
TCM malfunction