DTC P1719:00 [Aw6A-El]: Notes

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DETECTION CONDITION AND POSSIBLE CAUSE

DTC P1719:00	Engine torque signal error (inaccurate signal)
DETECTION CONDITION	With all of the following conditions met, if the engine torque signal from the PCM, which is transmitted using the CAN communication, is not normal and the condition has continued for 0.02 s or more Engine speed: 500 RPM or more Accelerator pedal opening angle: 2 % or more Diagnostic support note: The MIL does not illuminate. The AT warning light does not illuminate. PENDING CODE is not available. FREEZE FRAME DATA is available. The DTC is stored in the TCM memory
POSSIBLE CAUSE	PCM malfunction TCM malfunction

DTC P1719:00

Engine torque signal error (inaccurate signal)

DETECTION CONDITION

With all of the following conditions met, if the engine torque signal from the PCM, which is transmitted using the CAN communication, is not normal and the condition has continued for 0.02 s or more
- Engine speed: 500 RPM or more
- Accelerator pedal opening angle: 2 % or more

Diagnostic support note:

The MIL does not illuminate.
The AT warning light does not illuminate.
PENDING CODE is not available.
FREEZE FRAME DATA is available.
The DTC is stored in the TCM memory

POSSIBLE CAUSE

PCM malfunction
TCM malfunction