Diagnostic procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has the FREEZE FRAME DATA been recorded on the repair order?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	INSPECT COUPLER COMPONENT CONNECTOR FOR POOR CONNECTION Switch the ignition to off. Remove the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL] .) Inspect for poor connection (such as damaged/pulled-out pins, corrosion) Is there any malfunction?	Yes	Repair or replace the terminal, then go to Step 7.
3		No	Go to the next step
4	INSPECT SHIFT SOLENOID F CIRCUIT FOR SHORT TO POWER SUPPLY Switch the ignition to off. Inspect for continuity between the following circuits Coupler component terminal B21 (wiring harness-side) and all terminals except B21/B16 (wiring harness-side) Coupler component terminal B16 (wiring harness-side) and all terminals except B21/B16 (wiring harness-side) Is there continuity?	Yes	Repair or replace the wiring harness for a possible short to power supply, then go to Step 7.
4		No	Go to the next step.
5	INSPECT SHIFT SOLENOID F CONNECTOR FOR POOR CONNECTION Switch the ignition to off Disconnect the shift solenoid F connector Inspect for poor connection (such as damaged/pulled-out pins, corrosion) Is there any malfunction?	Yes	Repair or replace the terminal, then go to Step 7.
5		No	Go to the next step.
6	INSPECT SHIFT SOLENOID F Inspect the shift solenoid F. (See SOLENOID VALVE INSPECTION [AW6A-EL] .) Is there any malfunction?	Yes	Replace the control valve body, then go to the next step (See CONTROL VALVE BODY REMOVAL/INSTALLATION [AW6A-EL] .)
6		No	Go to the next step
7	VERIFY TROUBLESHOOTING OF DTC P0999:00 COMPLETED Make sure to reconnect all the disconnected connectors. Clear the DTC using the M-MDS. Perform the following procedure to ensure that the DTC has been resolved Start the engine. Warm up the engine and transaxle Drive the vehicle in D range and make sure that the gears shift smoothly from 1GR to 6GR Is the same DTC present?	Yes	Replace the TCM, then go to the next step (See TCM REMOVAL/INSTALLATION [AW6A-EL] .)
7		No	Go to the next step.
8	VERIFY NO DTC HAS BEEN PRESENTED Perform the "Reading DTCs Procedure". (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [AW6A-EL] ) Are any DTCs present?	Yes	Go to the applicable DTC inspection (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [AW6A-EL] .)
8		No	DTC troubleshooting completed