DTC P0883:00 [Aw6A-El]: Notes

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DETECTION CONDITION AND POSSIBLE CAUSE

DTC P0883:00	TCM B+ high
DETECTION CONDITION	Voltage of 18 V or more detected at TCM terminals A1 and A11 when engine is running. Diagnostic support note: The MIL illuminates if the TCM detects the above malfunction condition during the first drive cycle. The AT warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle. PENDING CODE is not available. FREEZE FRAME DATA is available. The DTC is stored in the TCM memory.
POSSIBLE CAUSE	Generator malfunction TCM malfunction

DTC P0883:00

TCM B+ high

DETECTION CONDITION

Voltage of 18 V or more detected at TCM terminals A1 and A11 when engine is running.

Diagnostic support note:

The MIL illuminates if the TCM detects the above malfunction condition during the first drive cycle.
The AT warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
PENDING CODE is not available.
FREEZE FRAME DATA is available.
The DTC is stored in the TCM memory.

POSSIBLE CAUSE

Generator malfunction
TCM malfunction