On-Board Diagnostic System Simulation Inspection [FS5A-El]
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the M-MDS to the DLC-2.
- After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- When using the IDS (laptop PC)
- Select "DataLogger".
- Select "Modules".
- Select "TCM".
- When using the PDS (Pocket PC)
- Select "Module Tests".
- Select "TCM".
- Select "DataLogger".
- When using the IDS (laptop PC)
- Select the simulation items from the PID table.
- Perform the simulation function, inspect the operations for each parts.
- If the operation of output parts cannot be verified after the active command mode inspection is performed, this could indicate the possibility of an open or short circuit, sticking, or operation malfunction in the output parts.
SIMULATION TABLE
| Item | Related to | Unit/Condition | Test condition |
|---|---|---|---|
| LPS | Pressure control solenoid A | A | Idling at P or N position |
| LPSB | Pressure control solenoid B | % | Idling at P or N position |
| SSA/SS1 | Shift solenoid A | % | Idling at P or N position |
| SSB/SS2 | Shift solenoid B | % | Idling at P or N position |
| SSC/SS3 | Shift solenoid C | % | Idling at P or N position |
| SSD/SS4 | Shift solenoid D | On/Off | Idling at P or N position |
| SSE_SS5 | Shift solenoid E | On/Off | Idling at P or N position |
| SSF_SS6 | Shift solenoid F | On/Off | Idling at P or N position |