DTC P0894:00 [FS5A-El]: Notes

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DETECTION CONDITION AND POSSIBLE CAUSE

DTC P0894:00	Transaxle component slipping
DETECTION CONDITION	The TCM detects that turbine revolution is more than 187 rpm when the following conditions are met. Vehicle stopped (brake pedal is depressed) Accelerator pedal is fully released Engine running at idle Selector lever position moved to D range from N position Diagnostic support note The MIL does not illuminate. The AT warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle. PENDING CODE is not available. FREEZE FRAME DATA is not available. The DTC is stored in the TCM memory.
POSSIBLE CAUSE	Shift solenoid A malfunction Forward clutch not engaged or slipped TCM malfunction

DTC P0894:00

Transaxle component slipping

DETECTION CONDITION

The TCM detects that turbine revolution is more than 187 rpm when the following conditions are met.
- Vehicle stopped (brake pedal is depressed)
- Accelerator pedal is fully released
- Engine running at idle
- Selector lever position moved to D range from N position

Diagnostic support note

The MIL does not illuminate.
The AT warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
PENDING CODE is not available.
FREEZE FRAME DATA is not available.
The DTC is stored in the TCM memory.

POSSIBLE CAUSE

Shift solenoid A malfunction
Forward clutch not engaged or slipped
TCM malfunction