DTC P0766:00 [FS5A-El]: Notes
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DETECTION CONDITION AND POSSIBLE CAUSE
| DTC P0766:00 |
Shift solenoid D stuck off |
| DETECTION CONDITION |
- The TCM detects that revolution ratio of the input revolution to output revolution is more than 1.249 or less than 0.6 when the following conditions are met.
- 4GR
- Vehicle speed: more than 25 km/h {16 mph}
Diagnostic support note
- The MIL illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM.
- The AT warning light illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM.
- PENDING CODE is available.
- FREEZE FRAME DATA is available.
- The DTC is stored in the TCM memory.
|
| POSSIBLE CAUSE |
- Deteriorated ATF
- ATF level low
- Shift solenoid D malfunction
- Line pressure malfunction
- Primary control valve body malfunction
- TCM malfunction
|