DTC P0735:00 [FS5A-El]: Notes

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DETECTION CONDITION AND POSSIBLE CAUSE

DTC P0735:00	Gear 5 incorrect ratio
DETECTION CONDITION	The TCM detects that revolution ratio of the intermediate revolution to output revolution in 3GR or 4GR is less than 1.11. The TCM detects that revolution ratio of the intermediate revolution to output revolution in 5GR is more than 1.11. Diagnostic support note The MIL does not illuminate. The AT warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle. PENDING CODE is not available. FREEZE FRAME DATA is not available. The DTC is stored in the TCM memory.
POSSIBLE CAUSE	Deteriorated ATF ATF level low Solenoid valve malfunction Pressure control solenoid B Shift solenoid F Line pressure malfunction Stall speed malfunction Direct clutch slipping Reduction brake slipping Secondary control valve body malfunction TCM malfunction

DTC P0735:00

Gear 5 incorrect ratio

DETECTION CONDITION

The TCM detects that revolution ratio of the intermediate revolution to output revolution in 3GR or 4GR is less than 1.11.
The TCM detects that revolution ratio of the intermediate revolution to output revolution in 5GR is more than 1.11.

Diagnostic support note

The MIL does not illuminate.
The AT warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
PENDING CODE is not available.
FREEZE FRAME DATA is not available.
The DTC is stored in the TCM memory.

POSSIBLE CAUSE

Deteriorated ATF
ATF level low
Solenoid valve malfunction
- Pressure control solenoid B
- Shift solenoid F
Line pressure malfunction
Stall speed malfunction
Direct clutch slipping
Reduction brake slipping
Secondary control valve body malfunction
TCM malfunction