Diagnostic procedure
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | PERFORM TCM DTC INSPECTION
|
Yes | Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FS5A-EL] .) (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [AW6A-EL] .) |
| No | Go to the next step. | ||
| 2 | VERIFY DTC TROUBLESHOOTING COMPLETED
|
Yes | Replace the DSC HU/CM, then go to the next step (See DSC HU/CM REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 3 | VERIFY AFTER REPAIR PROCEDURE
|
Yes | Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) |
| No | DTC troubleshooting completed | ||