Diagnostic procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

STEP	INSPECTION		ACTION
1	VERIFY DTC TROUBLESHOOTING COMPLETED Clear the DTC from the DSC HU/CM memory using the M-MDS (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] ) Drive the vehicle at speed of 3 km/h {2 mph} or more Gradually slow down and stop the vehicle Perform the DSC DTC inspection (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] ) Is the same DTC present?	Yes	Replace the combined sensor, then go to the next step (See COMBINED SENSOR REMOVAL/INSTALLATION .)
1		No	Go to Step 3.
2	VERIFY DTC TROUBLESHOOTING COMPLETED Clear the DTC from the DSC HU/CM memory using the M-MDS (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) Drive the vehicle at speed of 3 km/h {2 mph} or more Gradually slow down and stop the vehicle Perform the DSC DTC inspection (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) Is the same DTC present?	Yes	Replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY AFTER REPAIR PROCEDURE Are any DTCs present?	Yes	Go to the applicable DTC inspection (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] )
3	VERIFY AFTER REPAIR PROCEDURE Are any DTCs present?	No	DTC troubleshooting completed.