A/C Compressor Pulley installation Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

If the SST is not properly positioned when the A/C compressor pulley is press-fit, the A/C compressor axle will interfere with the SST, possibly damaging component parts. Verify the SST and axle are properly positioned and perform the procedure very carefully.

Install the inner wheel of the pulley using a press and SST (49 B034 212) to the compressor.
Substitution SST
- 49 B034 212
  Outer diameter: 48 mm {1.9 in} or less
  
  Inner diameter: 36 mm {1.4 in} or more
  
  Plate thickness: 1 mm {0.04 in} or more
  
  Height: 30 mm {1.2 in} or more
  
  Fig 1: Installing Inner Wheel Of Pulley To Compressor
  Courtesy of MAZDA MOTORS CORP.