LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 575 (Fuel System (MZI-3.7)) >> Quick Release Connector Removal/Installation [MZI-3.7] >> When Using SST 49 E042 001

When Using SST 49 E042 001

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • If the quick release connector is removed, replace the retainer with a new one.
  1. Complete the "BEFORE SERVICE PRECAUTION". See BEFORE SERVICE PRECAUTION [MZI-3.7] .
  2. Set the SST parallel to the quick release connector.
    NOTE:
    • The quick release connector can be removed by pushing the center of the retainer tabs.
    • The retainer is attached to the pipe even after the connector is disconnected.
    Fig 1: Disconnecting Quick Release Connector
    G06204997Courtesy of MAZDA MOTORS CORP.
  3. Hold the center of the retainer tabs with the SST ends and press the retainer.
  4. Pull the connector side and disconnect the quick release connector.
  5. Raise a retainer tab using the SST and remove the retainer.
  6. Cover the disconnected quick release connector and fuel pipe with vinyl sheeting or a similar material to prevent it from scratches or dirt.
Fig 2: Using SST To Disconnect Quick Release Connector
G06205029Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals