LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 575 (Fuel System (MZI-3.7)) >> Fuel Injector Removal/Installation [MZI-3.7] >> Fuel Injector Installation Note

Fuel Injector Installation Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new O-ring.
  2. Lightly lubricate the injector groove and O-ring.
  3. Pre-attach a new clip in the injector groove.
    NOTE:
    • When the clip is attached correctly, the central area of the injector and the clip finger positions are aligned.
  4. Hold the injector firmly, push the clip into the injector until the clip stops sliding.
  5. Verify that the injector connector position is correct, and press the injector and clip into the injector cup. Continue pressing until the clip contacts the lower surface of the injector cup.
  6. Verify that the injector and clip are correctly attached with the clip locked onto the injector cup notch.
Fig 1: Pressing Injector And Clip Into Injector Cup
G04969591Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals