Diagnostic procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

STEP	INSPECTION	RESULTS	ACTION
1	Inspect the following components for loose attaching bolts or worn parts: Cooling fan Drive belt and pulleys Generator Engine mounts Exhaust system mounts All items normal?	Yes	Inspect the following systems. Wheels ATX Driveline Suspension
No	Readjust or retighten engine mount installation position Service if necessary for other parts
2	Verify test results If normal, return to diagnostic index to service any additional symptoms (See SYMPTOM DIAGNOSTIC INDEX [MZI-3.7] .) If malfunction remains, inspect related Service Bulletins and/or On-line Repair Information and perform repair or diagnosis If vehicle is repaired, troubleshooting completed If vehicle is not repaired or additional diagnostic information is not available, reprogram the PCM if a later calibration is available. Retest

STEP

INSPECTION

RESULTS

ACTION

Inspect the following components for loose attaching bolts or worn parts:

Cooling fan
Drive belt and pulleys
Generator
Engine mounts
Exhaust system mounts

All items normal?

Yes

Inspect the following systems.

Wheels
ATX
Driveline
Suspension

Readjust or retighten engine mount installation position
Service if necessary for other parts

Verify test results
- If normal, return to diagnostic index to service any additional symptoms (See SYMPTOM DIAGNOSTIC INDEX [MZI-3.7] .)
- If malfunction remains, inspect related Service Bulletins and/or On-line Repair Information and perform repair or diagnosis
  - If vehicle is repaired, troubleshooting completed
  - If vehicle is not repaired or additional diagnostic information is not available, reprogram the PCM if a later calibration is available. Retest