LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 572 (Engine Mechanical [Lubrication System MZI-3.7)) >> Oil Pressure Inspection [MZI-3.7]

Oil Pressure Inspection [MZI-3.7]

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled.
  • Continuous exposure to USED engine oil has caused skin cancer in laboratory mice. Protect your skin by washing with soap and water immediately after working with engine oil.
  1. Disconnect the negative battery cable.
  2. Remove the engine cover. See ENGINE COVER REMOVAL/INSTALLATION [MZI-3.7] .
  3. Remove the oil pressure switch.
    NOTE:
    • This inspection can be performed using a combination of SSTs 49 0187 280A  (oil pressure gauge), 49 T018 006  (hose) and 49 T018 007  (adapter), or using the following combination of the SSTs  .
      • 49 D019 908  (gauge), 49 D019 909  (hose), 49 D019 910  (adapter), 49 D019 911  (adapter), and 49 D019 914  (adapter)
  4. Screw the SSTs  into the oil pressure switch installation hole.
  5. Connect the negative battery cable.
  6. Warm up the engine to normal operating temperature.
  7. Run the engine at the specified speed, and note the gauge readings.
    • If not within the specification, inspect for the cause and repair or replace if necessary.
    NOTE:
    • The oil pressure can vary with oil viscosity and temperature.
    Fig 1: Identifying Oil Pressure Gauge
    G06204925Courtesy of MAZDA MOTORS CORP.

    Oil pressure (reference value) 

    [oil temperature: 93.3°C {200°F}] 

    310-621 kPa {3.17-6.33 kgf/cm 2  , 45.0- 90.0 psi} [2,000 RPM] 

  8. Stop the engine and wait until it is cool.
  9. Disconnect the negative battery cable.
  10. Remove the SSTs  .
    CAUTION:
    • Be sure there is no sealant adhering to the first two threads from the end of the oil pressure switch to prevent a possible operation malfunction.
  11. Apply silicone sealant to the oil pressure switch threads as shown in the figure.
  12. Install the oil pressure switch.

    Tightening torque 

    11-18 N.m {113-183 kgf.cm, 98-159 in.lbf} 

  13. Connect the negative battery cable.
  14. Start the engine and confirm that there is no oil leakage.
    Fig 2: Applying Silicone Sealant To Oil Pressure Switch
    G04969490Courtesy of MAZDA MOTORS CORP.
    • If there is oil leakage, repair or replace the applicable part.
  15. Install the engine cover. See ENGINE COVER REMOVAL/INSTALLATION [MZI-3.7] .
scientia non olet · About LEMON Manuals