LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 571 (Engine Control System (MZI-3.7)) >> Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Removal/Installation [MZI-3.7]

Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Removal/Installation [MZI-3.7]

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Disconnect MAF/IAT sensor connector.
  3. Remove the MAF/IAT sensor.
  4. Install in the reverse order of removal.
    Fig 1: MAF/IAT Sensor With Torque Specifications
    G06205273Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals