Crankshaft Position (CKP) Sensor Removal/Installation [MZI-3.7]

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Disconnect the connector after the CKP sensor is removed to prevent the CKP sensor from falling off.
The bolt and sensor are integrated and cannot be pulled out.
When removing the CKP sensor, be careful not to drop the tool.
The bolt and sensor must be pulled in different directions. Pull them as indicated in the figure.

Disconnect the negative battery cable
Remove the following part for easier access.
1. Remove the Catalytic Converter (WU-TWC) (LH). See EXHAUST SYSTEM REMOVAL/INSTALLATION [MZI-3.7] .
  
  Fig 1: Identifying Crankshaft Position Sensor
  Courtesy of MAZDA MOTORS CORP.
Remove in the order indicated in the table.
Install in the reverse order of removal.

Fig 2: Identifying Crankshaft Position Sensor Removal/Installation Order
Courtesy of MAZDA MOTORS CORP.