LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 570 (Engine Mechanical [Service Information MZI-3.7]) >> Timing Chain Removal/Installation [MZI-3.7] >> Engine Front Cover and No. 3 Engine Mount Bracket Removal Note

Engine Front Cover and No. 3 Engine Mount Bracket Removal Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen the engine front cover and No. 3 engine mount bracket bolts in the order shown in the figure.
    2. Fig 1: Identifying Engine Front Cover Bolt Removal Sequence
    G04969363Courtesy of MAZDA MOTORS CORP.
  2. Install 4 of the engine front cover bolts (finger tightened) into the 4 threaded holes in the engine front cover.
    1. Tighten the bolts one turn at a time in a crisscross pattern until the engine front cover-to-cylinder block seal is released.
    2. Remove the engine front cover.
      Fig 2: Locating Engine Front Cover Bolts
      G04969364Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals