LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 570 (Engine Mechanical [Service Information MZI-3.7]) >> Timing Chain Removal/Installation [MZI-3.7] >> Crankshaft Pulley Removal Note

Crankshaft Pulley Removal Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the washer from the crankshaft pulley lock bolt, install a suitable spacer (thickness: approx. 14 mm {0.55 in}  , diameter: approx. 30 mm {1.2 in}  ), (similar to front shock absorber lower nut) to the crankshaft pulley lock bolt, and install the crankshaft pulley lock bolt to the crankshaft.
    Fig 1: Identifying Crankshaft Pulley Lock Bolt & Spacer
    G04969357Courtesy of MAZDA MOTORS CORP.
  2. Remove the crankshaft pulley using the SST  .
    3. Fig 2: Removing Crankshaft Pulley
    G04969358Courtesy of MAZDA MOTORS CORP.
  3. Remove the crankshaft pulley lock bolt and spacer.
scientia non olet · About LEMON Manuals