LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 570 (Engine Mechanical [Service Information MZI-3.7]) >> Timing Chain Removal/Installation [MZI-3.7] >> Crankshaft Pulley Lock Bolt Removal Note

Crankshaft Pulley Lock Bolt Removal Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the starter. (See STARTER REMOVAL/INSTALLATION [MZI-3.7] .)
  2. Set a flathead screwdriver to the drive plate in the position indicated in the figure to lock the crankshaft rotation.
    3. Fig 1: Locking Crankshaft Rotation
    G04969356Courtesy of MAZDA MOTORS CORP.
  3. Remove the crankshaft pulley lock bolt and washer.
scientia non olet · About LEMON Manuals