Crankshaft Pulley Installation Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Lubricate the contact surface (exterior area of inner diameter) of the front oil seal with clean engine oil.

Install the crankshaft pulley, washer, and SST to the crankshaft.

Fig 1: Installing Crankshaft Pulley, Washer & SST To Crankshaft
Courtesy of MAZDA MOTORS CORP.
Tighten the SST nut and install the crankshaft pulley.

Fig 2: Installing Crankshaft Pulley
Courtesy of MAZDA MOTORS CORP.