LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 570 (Engine Mechanical [Service Information MZI-3.7]) >> Front Oil Seal Replacement [MZI-3.7] >> Crankshaft Pulley Lock Bolt Installation Note

Crankshaft Pulley Lock Bolt Installation Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Rotate the crankshaft clockwise, and set a wrench to the drive plate bolt at the position shown in the figure to lock the crankshaft rotation.
    2. Fig 1: Locking Crankshaft Rotation
    G04969439Courtesy of MAZDA MOTORS CORP.
  2. Tighten the new crankshaft pulley lock bolt in 4 steps.
    1. Tighten to 140 N.m {14 kgf.m, 103 ft.lbf}  .
    2. Loosen 360  ° (one full turn) in reverse order.
    3. Tighten to 47-53 N.m {4.8-5.4 kgf.m, 35-39 ft.lbf}  .
    4. Tighten 85  °-95  °.
  3. Verify the tightening torque for the drive plate bolt to which the wrench has been set.
  4. Install the cover as shown in the figure.
    Fig 2: Identifying Cover & Fastener
    G06199313Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals