LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 570 (Engine Mechanical [Service Information MZI-3.7]) >> Front Oil Seal Replacement [MZI-3.7] >> Crankshaft Pulley Installation Note

Crankshaft Pulley Installation Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Lubricate the contact surface (exterior area of inner diameter) of the front oil seal with clean engine oil.
  1. Install the crankshaft pulley, washer, and SST  to the crankshaft.
    Fig 1: Installing Crankshaft Pulley, Washer & SST To Crankshaft
    G04969388Courtesy of MAZDA MOTORS CORP.
  2. Tighten the SST  nut and install the crankshaft pulley.
    Fig 2: Installing Crankshaft Pulley
    G04969433Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals