LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 570 (Engine Mechanical [Service Information MZI-3.7]) >> Engine Removal/Installation [MZI-3.7] >> No. 1 Engine Mount Removal Note

No. 1 Engine Mount Removal Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transverse member. (See TRANSVERSE MEMBER REMOVAL/INSTALLATION .)
  2. Remove the intermediate shaft bolt, and disconnect the steering shaft. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [WITHOUT ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [WITH ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .)
  3. Remove the No. 1 engine mount, No. 1 engine mount bracket and the front crossmember as a single unit. (See FRONT CROSSMEMBER REMOVAL/INSTALLATION [MZI-3.7] .)
    Fig 1: Identifying No. 1 Engine Mount
    G04969446Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals