LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Manual Transaxle [Service, Removal & Installation G66M-R)) >> Manual Transaxle Removal/Installation [G66M-R] >> Manual Transaxle Installation Note

Manual Transaxle Installation Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Install the transaxle carefully, holding it steady. If the transaxle falls it could be damaged or cause injury.
  1. Set the transaxle on a jack and lift into place.
  2. Install the transaxle mounting bolts.
  3. Adjust the SST  (49 C017 5A0) so that the engine is located at the specified position.
    Fig 1: Setting Transaxle On Jack
    G06205825Courtesy of MAZDA MOTORS CORP.
  4. Install the brake hose to the bracket and tighten the bolt shown in the figure.
    Fig 2: Illustrating Bracket Bolt Removal/Installation
    G06205823Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals