Starter Interlock Switch installation Note
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- The starter interlock switch may not operate normally If the rod is pushed in. Do not push in the rod when installing the starter interlock switch.
- Insert a new starter interlock switch into the pedal bracket hole in the direction of arrow A.
- While pressing the starter interlock switch in the direction of arrow A, slide it until it locks in the direction of arrow B to secure it.
- Fully depress the clutch pedal in the direction of arrow C and adjust the push rod protrusion of the starter interlock switch.