Brake Pedal Play Inspection
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Depress the pedal a few times to eliminate the vacuum in the system.
- Remove the snap pin and clevis pin, verify that the holes in the fork and in the pedal are aligned, and reinstall the pin. See BRAKE PEDAL REMOVAL/INSTALLATION .
- Gently depress the pedal by hand until resistance is felt, and check the pedal play.
Brake pedal play
4-8 mm {0.2-0.3 in}