Brake Pedal Height Adjustment
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- The brake switch may not operate normally after adjusting the pedal height. Whenever adjusting the pedal height, replace the brake switch with a new one.
- Loosen locknut A and turn the bolt B until it does not contact the pedal.
- Remove the snap pin and clevis pin
- Remove the brake pedal installation nuts C
- Move the power brake unit component a little toward the vehicle front while being careful of the brake pipes.
- Loosen locknut D and turn the fork E to adjust the height
- Tighten the locknut D and the brake pedal installation nuts C. See POWER BRAKE UNIT REMOVAL/INSTALLATION .
- Install the snap pin and clevis pin
- Turn the bolt B and adjust the clearance between the bolt B and the rubber.
Clearance
1.2-2.2 mm {0.048-0.086 in}
- Tighten the bolt B with locknut A
Tightening torque
10-14 N.m {102-142 kgf.cm, 89-123 in.lbf}
- After adjustment, inspect the pedal play and the brake light operation