LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 564 (Entertainment System) >> Accessory Socket Inspection >> Rear

Accessory Socket Inspection: Rear

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Upper panel. See UPPER PANEL REMOVAL/INSTALLATION .
    2. Shift knob (MTX). See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .
    3. Shift panel. See SHIFT PANEL REMOVAL/INSTALLATION .
    4. Decoration panel. See DECORATION PANEL REMOVAL/INSTALLATION .
    5. Center panel lower. See CENTER PANEL LOWER REMOVAL/INSTALLATION .
    6. Rear console. See REAR CONSOLE DISASSEMBLY/ASSEMBLY .
    7. Accessory socket (Rear). See ACCESSORY SOCKET REMOVAL/INSTALLATION .
  3. Connect a tester as shown in the figure and verify that there is continuity.
    • If the continuity cannot be verified, replace the accessory socket (Rear).
      Fig 1: Connecting Tester
      G06201199Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals